Software module 149 - VW Passat 3C comfort and ECU with ID48

Depending on job with car you have these options:

• If job is NEED SPARE KEY,you need ONLY file from comfort unit.
• If job is LOST ALL KEYS,after loading of comfort file software offers to you 3 options:
  • Load file from engine ECU.Supported are EDC16,MED9 not crypted,SIMOS PPD/SIMOS7
  • Enter first 6 bytes of component security.Use any tool to read them by OBD2
• If you use options 1 or 2,software will save new file for comfort unit and will program key.You must program comfort with new file and car will start with programmed key.
• If with your car ECU file is crypted or you can`t read first 6 bytes of CS your solution is 3 - make attempts with key until adopted by car.
• Use this option when ECU file is crypted or no way to read first 6 bytes of component security.
• Software will save new file and you must program comfort with it.After that you must do this sequence "program key with TMPro - try key in car" until car starts with new key.
• Maximal number of attempts is 256.Time for one attempt "program key with TMPro - try key in car" is no more than 15 seconds.
• If by any reason you interrupt sequence,software allows you to continue from the point,where it was interrupted,so no need to start it from begining.
• For engine ECU supported are EDC16 with eeprom 95c320,MED9 with 95c080,Siemens SIMOS PPD with 95c320 and Siemens SIMOS7 with 93c86.For comfort unit eeprom is 95c320.
• Use Megamos Crypto or Silca T6 - JMA TP08 transponder.
• Written transponder is ready programmed to start the vehicle.
• Software also shows PIN code.

Vehicles equipped with this unit:

VW:

• VW:Passat
• 3C (B6/CC)