Follow the steps below:

• Open central locking system ( ZV ) using the car key. You must initiate the central locking system first.
• Get into the car and close all doors.
• Using the car key, switch the ignition lock briefly to ignition lock position 1 and switch off again. The switching time must remain under 5 seconds, otherwise the system is not ready for initialization. You must insert & turn the key to ignition switch position 1 ( not position 2 )
• At the radio transmitter : Press button #2 and hold in. You must then remove the key from the ignition and press & hold button #2 within 5 seconds of removal.
• Press button #1 three times ( in a space of 10 seconds ). Button #2 must remain held in. You then have up to 10 seconds to press the Roundel button THREE times ( while still holding down button #2 ).
• Relase button #2
• The ZV signals by means of "Locking" and immediate "Unlocking" that a radio transmitter has been successfully initialized..

If you have any additional remote keys - you start their programming on STEP 4 Do not insert any additional remote key into the ignition switch - if you do - the 1st key will lose it's programming.

If the ZV does not send a return signal, initialization bust be restarted. Once the first initialization process has been completed, another three radio transmitters can be initialized. For every radio transmitter, the procedure described under 4 above must be repeated within 30 seconds, otherwise initialization stand-by is switched off. During initialization, all other existing radio transmitters must be initialized. The ignition lock must never be reactivated during the initialization process. If this were to happen, then all radio transmitters would have to be re-initialized.