PN013 - BSI, Instrument cluster data manager

With this special function you can read and and calibrate the mileage stored in the BSI module and remove the synchronization with the instrument cluster (i.e. The modification is performed in the BSI exclusively and after a complete ignition cycle the mileage is not restored to the original value). In the cases where the sync removal does not apply it can calibrate the mileage in the cluster exclusively. Supported models are all CAN and UDS protocol models which includes almost all models produced after 2004. This function can be used independently.

Supported Vehicles for Calibration: 

BSI Exchange - allows you to read the whole content of the one BSI (JCI or Valeo CAN) and transfer it to another one. It is very important to use the same hardware type for the replacement BSI. The Valeo BSIs are two types - the old one is thick, while the new one is thin, so they can’t be mistaken. To use this special function you need to have PN012 + PN013 special functions. The UDS BSI modules are supported via read/write EEPROM and flash.

New AVDI Interface or activate AMS is required to purchase this special functions.